We do offer free online introductory test and tag training through our Bronze course, which gives you a lot of information to get you started in test and tag and teaches you some basics about staying safe around electricity. Click here to see more. We also offer a free health and safety managers course for […]
We are pleased to announce that we now do offer online initial AS/NZS 3551 Medical training and Online Refresher AS/NZS 3551 Medical training. Click the here to find out more.
Absolutely you can. In fact there are a lot of benefits to doing it online including more flexibility for the completion of your training. Simply complete our three levels; Bronze, Silver and Gold.Metrotest
The printer has not sensed the labels properly. This could be because the labels are not properly installed. Open the printer and check that labels are in the guides.
The printer could be out of labels/ribbon or the memory is confused. Check labels, ribbon and turn off for one minute and back on.
It may be out of label or ribbons. Open printer, check and replace as necessary. If this does not work, try turning the whole device off and on again.
You will need to carry out a manual RCD test. Firstly test the multibox using test code 168 for a IT/surge type multibox. If it passes this test select; Manual Tests , RCD, 15mA test option. Contact us for free if you need further advice.
Yes you do. If the test lead is not connected the tester will not give a correct reading, you could potentially pass an appliance that should fail this test.
Check that there is a good connection between your test lead and the metal you are measuring to. If it is dirty or corroded you can see sparking. If you have doubts about proceeding with tests seek further advise.
Generally no, this depends on the set up of the equipment and the workplace environment. Refer to AS/NZS 3760 for definitions of hostile and non-hostile environments. Quite often offices should only be tagged for 12 months.